Spine Creaser - FAQs and Technical Support

The Spine Creaser is simple to use and the learning curve is usually brief. Installation on most models takes about 30-45 minutes. Product details vary quite a bit from one saddle stitcher to another so be sure to ask if you have any questions. (The photo at left shows a Spine Creaser to fit Muller 1528 or 1529 cover feeders.)

If you are just getting started, or have basic product questions, review the FAQs (Frequently Asked Questions) below to get answers. If you have operating problems, use the Troubleshooting Questions section below.

Or use our Contact Form to email your question. Be sure to include as much detail as possible.

Instruction Manuals and Tip Sheets - Technifold Spine Creaser

Technifold Spine Creasers are available to fit cover feeders on the following saddle stitching machines. The Instruction Manuals are PDF documents that will open in a new browser window. Or right click and 'Save As' or 'Save Target As' to download directly to your computer.

Muller 1528 or 1529 Cover Feeders - Download Here

Muller 1553 or 1554 Cover Feeders - Download Here

Heidelberg ST100, ST300 or ST400 Cover Feeders - Download Here

Heidelberg ST350 or ST450 Cover Feeders - Download Here

Osaka Cover Feeder with Flat Style Cylinder - Download Here

Osaka Cover Feeder with Grooved Style Cylinder - Download Here

Harris ProSetter Cover Feeder (also Macey or Sheridan) - Download Here

Basic Product FAQ's - Technifold Spine Creaser

Stay tuned.

Troubleshooting Questions - Technifold Spine Creaser

Stay tuned.